elsner elektronik 71160, Установка и настройка

Страница: 22 / 38

20 Setting the parameters
KNX eTR 205/206 Light push button • Version: 16.12.2020 • Technical changes and errors excepted
Block
The switching output can be blocked using an object.
Set the cases in which threshold vlaues and delay times received per object are to be
retained.
The behaviour of the switching output on release is dependent on the value of the pa-
rameter "Switching output sends" (see "Switching output")
9.5. Temperature PI controller
Activate the controller if you want to use it.
General rules
Decide in which cases nominal values and delay times received per object are to be
kept. The parameter is only taken into consideration if the setting by object is activated
further down. Please note that the setting "After power restoration and programming"
should not be used for the initial start-up, as the factory settings are always used until
the first call (setting via objects is ignored).
For an adequate regulation of the indoor temperature, comfort, standby, eco and build-
ing protection modes may be used.
Use switching output block No • Yes
Assessment of the block object • At value 1: block | At value 0: release
• At value 0: block | At value 1: release
Blocking object value before first Commu-
nication 0 • 1
Switching output behaviour
On blocking • Do not send message
• 0 Send
• 1 Send
On release
(with 2 second release delay) [Dependent on the "Switching output
sends" setting]
Switching output sends on change • Do not send message
• Send switching output status
Switching output sends on change to 1 • Do not send message
• if switching output = 1

send 1
Switching output sends on change to 0 • Do not send message
• if switching output = 0

send 0
Switching output sends on change and
periodically Send switching output status
Switching output sends on change to 1 and
periodically if switching output = 1

send 1
Switching output sends on change to 0 and
periodically if switching output = 0

send 0
Use controller No • Yes