20
Remote control set-up
Remote control Remo KNX RF
• Version: 14.02.2018 • Technical changes and errors excepted.
7.3.
System
Information about the software version and serial number; resetting the remote control to
factory defaults and activating the transport block; setting the language.
Menu: System.
(1) Swipe the screen from the top edge downwards to open the settings menu.
(2) Tap
System
.
(3) You can read the serial number and software version, and perform the following actions:
Setting the language:
Tap
Language settings
and select the desired language (German, English, French, Italian
or Spanish).
Factory defaults:
ATTENTION!
•
Resetting to factory defaults deletes all custom settings!
Channel names are reset to the name specified in the ETS.
•
The configurations introduced in the ETS are permanent!
Channels and their functions can only be deactivated in the ETS
(Reprogramming).
Hold down
Reset to factory defaults
for at least 5 seconds to delete the settings saved
on the remote control.
Transport block:
Hold down
Activate transport block
for at least 5 seconds to prepare the remote control
for transport. The transport block prevents the device from being activated when it is
moved. To unblock, connect the remote control to the power supply using a charging cable.
Tap
Back
at the bottom edge to return to the previous settings menu. Swipe from the bot-
tom edge upwards to close the settings menu.
1
2
3
