24
Parameter setting
Radio Actuator KNX RF S1R-B2 compact
• Version: 16.09.2020 • from application 1.0 •
Technical changes and errors excepted.
6.2.1.2.Manual
Position memory for the manual movement can be activated here. The position set
here can be overwritten via a learning object at any time. The memorised position can
be retrieved again at a later time.
For shutters, both the movement and the slat position can be stored.
6.2.1.3.Automation - external
The ‘External automation’ menu item appears if the external automation is selected in
‘Control’. In this case, the position memory can be activated for the automatic
movement. The position set here can be overwritten via a learning object at any time.
The memorised position can be retrieved again at a later time. For configuration
options, see Chapter ‘Manual’ on Page 31.
6.2.1.4.Scenes (drives)
A group address for scenes
must be filed in the KNX system to control the scenes.
The input object ‘Channel X: call/save scenes’ of the actuator is linked to this group
address.
A scene is
called
, then the
scene number
is communicated to the actuator. The
movement position saved for this scene number in the actuator is then taken.
If the scene
saving
function is used, then the current movement position is saved for
this scene number in the actuator.
The ‘Scenes’ menu item of the actuator is only shown if ‘Use scenes: yes’ was selected
in the settings for the drive channel. Every drive can
have up to 16 scene save
points
for movement positions.
Activate a scene save point.
Assign a scene number to the scene save point. Use this scene number to call/save the
movement position stored in the actuator. Make sure that every scene number is used
only once per drive channel.
Use position memory
no • yes
Use different positions for object values 0
and 1
no • yes
(if ‘yes’ is selected, there will be a division
into positions for object value 0 and object
value 1)
Position in %
0...100
Allow calling via command sequence: long-
term = 1, short-term = 1
no • yes
Use learning object for new position
no • yes
Transfer when programming
(when learning object is used)
• all parameters
• changed parameters only
Use scene save point X
no •
yes
