elsner elektronik 70391, Установка и настройка

Страница: 8 / 18

6 Addressing of the device at the bus
Door operator control module KNX A3-B2 • Version: 17.12.2019 • Technical changes and errors reserved.
2.3. Notes on mounting and commissioning
Device must not be exposed to water (rain). This could result in the electronics being
damaged. A relative air humidity of 95% must not be exceeded. Avoid condensation.
After the bus voltage has been applied, the device will enter an initialisation phase last-
ing a few seconds. During this phase no information can be received or sent via the
bus.
3. Addressing of the device at the bus
The device is supplied with the bus address 15.15.250. You can program another ad-
dress into the ETS by overwriting the 15.15.250 address or by teaching via the pro-
gramming button.
Fig. 3
4-wire connection line for binary inputs:
Connection of the outputs independent from polarity.
violet input 1
yellow input 1
white input 2
black input 2