elsner elektronik 70151, Установка и настройка

Страница: 24 / 30

22 Parameter setting
Ultrasonic Probe KNX SO250 • Version: 14.09.2020 • Technical changes and errors excepted.
7. Parameter setting
7.1. General settings
7.1.1. Distance measurement
Sensor settings:
Measuring behaviour:
Note: If the measurement is made on request the measured value will be sent imme -
diately.
Transmission behaviour:
7.1.2. Fill level measurement
Sensor settings:
Sensor measures Distance • Filling level
Distance offset in cm 12 … 200
Use malfunction object Yes • No
Perform measuring cyclically • on request and cyclically
Use object measuring block
If the object is used:
for value: 1 = Block measurement |
0 = release measurement
Value before 1st communication: 0 Yes • No
Measured value • send cyclically
• send in case of change
• send in case of change and cyclically
from change in %
(only for sending "in case of change") 1 … 50
send cyclically every
(only for "cyclic" sending) 5 sec … 2h
Output of the measured value in m
General sending delay
after power up and programming 5 sec • 10 sec • 20 sec • 30 sec • 1 min •
2 min • 5 min
Sensor measures Distance •
Filling level
Use malfunction object Yes • No