99
Commissioning
Control System WS1 Color / WS1000 Color
• Version: 14.12.2016 • Technical changes and errors excepted.
on the control system) and location (if there is a DCF77 weather station on the control
system) must be set.
System > WS1/1000 Settings > Settings > Time and Date
6.2.Enter time and date manually
System > WS1/1000 Settings > Settings > Time Zone
6.2. Select time zone
System > WS1/1000 Settings > Settings > Location
6.2. Enter location
5.1.2. Check sensor functions
On the display the current values for sun, wind and outdoor temperature are shown.
First check the sensor functions.
Light intensity (sun sensor)
The sunlight sensor is beneath the weather station lid. If there is not enough brightness
at the moment, light up the weather station with a powerful table lamp until a value is
shown.
Direction and height (sun)
The direction and height of the sun is calculated by the control unit based on the date/
time and location. The time is set upon receipt of a time signal from the unit itself (can
take up to 10 minutes). If no signal is available, the time can be set manually. If a weath-
er station with GPS receiver is connected to the control system, the time zone must be
selected from the menu. With a DCF77 receiver, the geographical location of the build-
ing must be input.
System > WS1/1000 Settings > Settings > Time and Date
6.2. Enter time and date manually
System > WS1/1000 Settings > Settings > Location
6.2. Enter location (only DCF weather stations)
Precipitation (Precipitation sensor)
Precipitation is shown with the “Rain” or “Snow” animation in the display. Moisten the
golden sensor surface on the weather station lid (often the moisture from the surface
of the skin when touching is enough). The “Precipitation” animation should then be-
gin.
Please take note that after the sensors dry out, the precipitation warning remains for a
further 5 minutes.