11
Operating the display
Solexa II Control
• from software version weather station 1.3, display 2.1 • Version: 11.05.2017
Technical changes and errors excepted.
Outdoor temperature in the set range. Heating is turned on.
1.4. Beeps
If a button or a touch sensitive area is actuated, a beep sounds. If a button has been
held down, then a higher beep sounds as confirmation that the button has been recog-
nised as held down. This is, for example, valid for the settings button in order to access
the default settings or the SET button to save.
Shortly before the display battery is flat, a warning signal sounds every 15 minutes
(combination of high and low beeps).
1.5. Error messages
If, instead of a sensor value, ER error is displayed then the wireless connection
to the weather station is disrupted or the sensor is defective.
Check whether the weather station is powered (fuse). Have the device checked by an
electrician if the problem continues.
Installation, testing, operational start-up and troubleshooting of the unit
should only be performed by an electrician (accredited according to
VDE 0100).
1.6. Table: Memory locations for the outputs and
inputs
In the table you can enter the devices that have been taught and the functions for the
individual memory location and note keywords for automatic mode set.
Memory
location
Type
Display
position
Room
Keyword
