ELSA LANCOM Wireless L-II, Руководство пользователя

Страница: 44 / 71

Operating modes and functions
|
|
ELSA LANCOM Wireless L-II
|
44
EN
4.1.4 Point-to-point network
On a point-to-point network (also called „Bridge mode“) two or more access
points communicate with each other. When configuring mobile stations,
proceed exactly as you would for setting up an infrastructure network. It is
also possible to connect point-to-point networks and infrastructure networks.
For the access points in this case, however, both the network name and the
radio frequency have to be the same and interpoint communication has to be
enabled. Furthermore, in the list of protocols you can only define the
protocols that are copied in the network. You can increase data throughput
by excluding any unneeded protocols.
The corresponding menu commands are as follows:
WEBconfig :
Advanced configuration Setup WLAN module
LANconfig:
Management Interfaces
WLAN access General Point-to-point
4.1.5 Wireless Internet gateway via DSL
The use of the LANCOM Wireless as a DSL router or DSL gateway is only
possible if your provider uses the PPPoE protocol.
For a wireless Internet gateway via DSL, proceed on the client side exactly as
you would for setting up an infrastructure network.
Configure the following settings for the access point:
First you have to load the DSL firmware into the access point. Note that,
after doing so, the LAN interface will no longer be available! It then
functions as a DSL interface.
Name list
Data for remote stations and the phone numbers. Here, for example,
enter the Internet provider you call for a DSL connection. The
recommended idle time is about 300 seconds. PPPoE is always used as
the protocol and you will not find a layer list for the DSL settings.
PPP list
Here enter the device name of the remote station and the password. If
100235 Wireless L-11.book Seite 44 Montag, 30. Oktober 2000 5:43 17