- 3 -
10
12V DC adapter (excl.) connection.
11
Press to perform a manual test.
12
Reset button.
13
Battery compartment; 3 x size D 1,5V included.
14
Level; help with mounting.
15
Input for adapter cord.
16
Opening the wall box.
3.
Pairing the facade box
•
The Home+ alarm system must be deactivated during the pairing and installation of the wall
box. Open the facade box by unscrewing the screw on the bottom. Insert the 3 batteries,
paying attention to the polarity (+ and -). Make sure that the ON/OFF switch is set to ON. The
LEDs will flash, wait about 5 minutes until the LEDs have stopped. If the LEDs do not flash but
are lit continuously, press the reset button until the wall box gives a signal and the LEDs still
flash.
•
Open the app and tap "Add accessories" (
1
).
•
Scan the QR Code on the back of the wall box (
2
).
•
Give the wall box a name, for example the location (
3
) and confirm with the blue "
V
" (
4
).
•
You get a confirmation; the siren of the wall box gives 2 "Beep" signals and the LEDs go on and
off.
4.
Setting the facade box/Status indication
You can set up the panel according to your personal preferences, such as how long and how
loud the siren should sound. You can also use the app to set the panel to flash the LEDs (1 x 15
seconds) to indicate the status of the Home+ alarm system. See also
