User Manual
–
ET6553L
UM600326 Rev A, page 27 of 37
Section 8: Regulatory Information
Waste Electrical & Electronic Equipment Directive (WEEE)
This product should not be disposed of with household waste. It should be deposited at a facility that
enables recovery and recycling.
Elo has put in place recycling arrangements in certain parts of the world. For information on how you can
access these arrangements, please visit www.elotouch.com/e-waste-recycling-program/.
Electrical Safety Information
Compliance is required with respect to the voltage, frequency, and current requirements indicated on the
manufacturer’s label. Connection to a different power source than those specified herein will likely result in
improper operation, damage to the equipment or pose a fire hazard if the limitations are not followed.
There are no operator serviceable parts inside this equipment. There are hazardous voltages generated by this
equipment which constitute a safety hazard. Service should be provided only by a qualified service technician.
Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting
the equipment to mains power.
Emissions and Immunity Information
Notice to Users in the United States. This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense. This device complies with Part 15C of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference; and
2) This device must accept any interference, including interference that may cause undesired operation of the
device.
