Elma 9400
18
v.200303
03-03-2020 12:23:54
ENGLISH
SAFETY INFORMATION
Do not operate the tester if the body of meter or the test lead look broken.
Check the main function dial and make sure it is at the correct position before each measurement.
Do not perform resistance and continuity test on a live power system.
Do not apply voltage between the test terminals and test terminal to ground that exceed the
maximum limit record in this manual.
Keep the fingers after the protection ring when measuring through the test lead.
Change the battery when the
symbol appears to avoid incorrect data.
Environmental Conditions
Operation Temperature: 0°C to 40°C(32°F to 104°F); < 80 % RH
Storage Temperature: -10°C to 60°C(14°F to 140°F
);
< 80 % RH
Explanation Symbols
Attention refer to operation Instructions.
Dangerous voltage may be present at terminals.
This instrument has double insulation.
Approvals:
EN61010 300V CAT IV
GENERAL SPECIFICATION
Digital Display: 4 digital liquid crystal(LCD), Maximum reading 5000.
Polarity: When a negative signal is applied, the
signal appears.
Low Battery Indication: When the battery is under the proper operation range,
will appear on
the LCD display.
Sample Rate: 2 times/sec for digital data.
Power Source: 1.5V size AAA battery X 2
Typical battery Life: (without buzzer, backlight)
Type: 30 hours at DCA function;
60 hours at ACA and ACV function;
100 hours at DCV and Ohm function.
Auto Power Off:
If there is no key or dial operation for 30 minutes, the meter will power itself off to save battery
consumption. This function can be disabled by press and hold the
“
HOLD
” button then power
the unit on
Over Load:
When the signal larger than the maximum will be show
.
Maximum jaw opening:
23 mm
Dimensions: 206 x 76 x 33.5 mm
Weight: 262g (with battery)
Accessories: Carrying case, Batteries, Test Lead & Instruction Manual.