Elkron MP500/16, Руководство по программированию

Страница: 95 / 140

MP500/4N-8-16 Programming 95
6 - USER REMOTE CONTROL
6.1 HOW TO SKIP A TELEPHONE ANSWERING MACHINE
The answering machine or fax must be set to pick up after at least two rings in order to be able to call the control panel for remote
management on the PSTN line. The Answer Machine function of the control panel must be set to pick up after more rings that th e
answering machine.
The control panel can then be called for remote control as follows:

Call the control panel and hang up after the first ring. The control panel will detect the incoming call without picking up because the
number of rings is lower than the set number.

Call the control panel back within 30 seconds.

The control panel will immediately engage the line after the first ring without counting the number of programmed rings. In t his
manner, the telephone answering machine or fax will receive only one ring and will engage the line instead of the control panel.
This procedure is implemented automatically also by Remote Control Centres with Hi-Connect software and enabled function.
6.2 REMOTE CONTROL WITH TEXT MESSAGES
Outputs programmed as “commandable” can be activated remotely by sending an SMS text message. The GSM answer machine and
the "Incoming SMS" GSM parameter must be enabled to use this function. Furthermore, the text message must come from a known
telephone number, i.e. one of the 12 telephone numbers stored on the control panel.
IMPORTANT! This number does not need to be associated to an event.
The text message to be sent to the telephone number of the SIM Card of the control panel must have the following syntax:
2nns.
where:

nn is the logical number from 01 to 10 of the commandable output or commandable pulse to be switched

s is a digit which represents the status that the output must assume: 1 (arm) or 0 (disarm). In case of pulsed commandable output
only 1 (arm) can be used;

.
(full stop) is the end of the message.
Several controls can be queued in the same text message and separated by a comma. The text message must end with a full stop
(“.”).
Any spaces will be ignored, but characters other than digits, spaces, commas and full stops will be considered errors. The text
message will be rejected.
EXAMPLES
Text message Description
2031. Correct: this message will activate logical output 03
2 03 1. Correct: this message will activate logical output 03
2031, 2050. Correct: this message will activate logical output 03 and deactivate logical output 05
2031 Wrong: no full stop at the end of the message
2 3 1. Wrong: the output number is not written using two digits
2031. 2050. Partially correct: the first command will be executed, the second one will be rejected
The control panel will send a reply text message containing exclamation marks
“!!!”
followed by the received message to confirm
command reception.