Elkron MP500/16, Руководство по программированию, Страница: 71 / 140

MP500/4N-8-16 Programming 71
4.20.2
Output test
Proceed as follows to test that the outputs work perfectly:
1) Enter < Master / Installer code > , press and then .
2) Press repeatedly until TEST appears.
3) Press and press repeatedly until TEST OUTPUTS appears.
4) Press .
5) Press and to select the device the outputs of which you want to test. Press to confirm.
6) Press and to select the output to test. Press to confirm.
7) The output will switch from ARM to DISARM every time is pressed. Check that the output
behaves as expected, e.g. that a siren sounds (if the output is connected to a siren) or that an
indicator lights up (if the output is connected to an indicator or blinker). Press to proceed if the
test was successful.
8) Repeat from step 6 to test the other outputs of the device.
9) After having tested all the outputs of the device, press and repeat from step 5 to test the
outputs of another device.
10) Press repeatedly to exit from the menu. The outputs will be returned to the correct state.
4.20.3
Battery test
Proceed as follows to check the condition of the batteries:
1) Enter < Master / Installer code > , press and then .
2) Press repeatedly until TEST appears.
3) Press and press repeatedly until TEST BATTERY appears.
4) Press .
5) The battery test will last for approximately 30 seconds during which the keypad will beep.
The battery status information provided by the LEDs and on the event log will be updated at the
end of the test (if there are changes). Any auxiliary power units will also run the battery test and
communicate the result to the control panel at the end. The failure LED will indicate flat batteries.
6) Press repeatedly to exit from the menu.
UT00:INSTALLER
TEST
UT01:MASTER
TEST
TEST
TEST OUTPUTS
TEST OUTPUTS
CONTROL PANEL
CONTROL PANEL
UC.U1 U01
UC.U1 U01
ARM
UT00:INSTALLER
TEST
UT01:MASTER
TEST
TEST
TEST BATTERY
TEST BATTERY
IN PROGRESS...