Elkron MP500/16, Руководство по программированию, Страница: 69 / 140

MP500/4N-8-16 Programming 69
4.19.2
Programming
ADVICE: Fill in the respective tables before starting to program the timed programmer (see 10.6 Timed programmer
configuration ): your work will be enormously simplified.
IMPORTANT! The time and date must be right for correct operation of the timed programmer (see paragraph 4.8 How to set
date and time ).
The following parameters must be configured during programming:

Day Type
: set whether each day of the week (Monday, Tuesday… Sunday) must be considered as a working day, a pre-holiday or
a holiday.

Command Type : up to eight commands can be set for each day type (working day, pre-holiday or holiday).

Command N : the time and action type is defined for each command.

Action : there are three possibilities: no action, arm (enable) and disarm (disable). The actions can be applied to partitions, outputs, users
and keys.

Warning Time : this determines how many minutes of warning must be given before the command is implemented. The warning
time allows to leave the area or to interrupt the automatic implementation of the command. The possible values are: no warning, 5
min, 10 min, 15 min, 20 min.
4.19.2.1
Programming procedure
Proceed as follows to program the timed programmer:
1) Enter <Installer code> , press , then and finally repeatedly until SETTINGS appears.
2) Press and then several times until P.O. appears.
3) Press .
4) Press .
5) Press and to select the concerned day. Press to confirm.
6) Press . Press and to select the type (working day, pre-holiday, holiday). Press to
confirm.
7) Repeat from step 5 to define the type of all days.
8) Press and then .
9) Press . Press and to select the concerned day type. Press to confirm.
10) Press and to select the concerned command number. Press to confirm.
11) Press .
12) Enter the time on which to implement the command using the keypad. Press to confirm.
13) Press .
14) Press . Press and to select the concerned command type (no action, arm, disarm).
Press to confirm. If arm (or disarm) is chosen, you can choose whether to apply the action to
partitions, outputs, users or keys and other details within each category. The selection procedures
are user-friendly.
UT00:INSTALLER
SETTINGS
SETTINGS
P.O.
P.O.
DAY TYPE
DAY TYPE
MONDAY
MONDAY
WORKING DAY
P.O.
COMMANDS TYPE
COMMANDS TYPE
WORKING DAY
WORKING DAY
COMMAND N:01
COMMAND N:01
COMMAND HOUR
COMMAND HOUR
HOUR 00:00
COMMAND N:01
COMMAND TYPE
COMMAND TYPE
NO ACTION