28
MP500/4N-8-16 Programming
4.2
HOW TO ENTER ALPHANUMERIC CHARACTERS
The keypad can be used to enter alphanumeric characters to store descriptive names for users, partitions, areas, outputs etc. Each
name can by up to 24 characters long. Press the keys to select several characters cyclically as shown on the following table. A cursor
will blink on the display at the entry point of the new character.
To write a name:
press the key associated to the required character until it appears
press
and
to go to the previous or next position (use
to delete characters in excess)
finally, press
to store the name or
to exit from the procedure without saving it.
Key
Character
Key
Character
1
. / : ; ! ? 1
6
M N O m n o 6
2
A B C a b c 2
7
P Q R S p q r s 7
3
D E F d e f 3
8
T U V t u v 8
4
G H I g h i 4
9
W X Y Z w x y z 9
5
J K L j k l 5
0
[space] 0 + -
4.3
VOCAL NAME
MP500/4N, MP500/8 and MP500/16 allow to assign a vocal name to partitions, inputs and outputs. This identification will be used in the
vocal messages sent by the control panel, including alarm messages. In order to use this function the MP500/4N, MP500/8 or
MP500/16 control panel must be equipped with a vocal synthesis board (SV500N). See the
Installation Manual
for more information on
connections and configurations of this device.
The playing, recording and deleting functions are available in the partition, input, output and radio device programming menu. Each
vocal name is four seconds long.
The headset with microphone supplied with the vocal synthesis board or alternatively a vocal keypad (KP500DV/N) can be used to
record and play. The delete command must be used to clear a memory position to record another vocal message.
IMPORTANT!
Speak at a distance of approximately 20cm from the microphone for good quality of the recorded audio.
Do not hold the vocal keypad, if this method is used, during recording.
4.4
HOW TO ENABLE THE INSTALLER
The Installer must have been previously enabled to work on the system. For safety reasons, Installer enabling is cancelled wh enever a
User or Master code is entered or when an electronic or proximity key is used.
IMPORTANT!
The Installer is automatically enabled each time the system is turned on.
Proceed as follows to enable the Installer:
1) Enter
<Master code>
, press
, then
and finally press
repeatedly until ENABLE
appears.
2) Press
.
3) Press
. If, necessary, press
to make ENABLE appear.
4) Press
to enable the installer.
5) Press
repeatedly to exit from the menu.
UT01:MASTER
ENABLE
ENABLE
INSTALLER
INSTALLER
ENABLE
ENABLE
INSTALLER
MP500/16
12/01/2014 10:10
Содержание MP500/16
Страница 139: ...MP500 4N 8 16 Programming 139 ...
