142
Outputs
The ACCESS procedure can be accessed from the
section.
Use this procedure to access the home automation outputs directly, if access not already
performed from
Access authentication
When you start the ACCESS procedure, a pop-up appears so you can authenticate who you are
if not already done in Burglar alarm section.
Digit a valid access code and press the
ACCESS
button. The access code is the 6-digit
numerical code used to access the alarm system via the physical keypad, not the password
used to access the Web Server.
WARNING
: If the access codes configured in the control panel are less than 6 digits long, it
must first be reconfigured as a 6-digit number in order to access the control panel via the
Web Server.
The
key cancels only the last digit and OK button is the same as ACCESS, it sends the
code to the system.
The operations that can be carried out after entering the system depend on the privileges
possessed by the access code inserted.
To close the pop-up window without attempting to access the system, click outside of the
virtual keypad and the pop-up or press the
X
icon on the pop-up. In this way, even if a code
has been inserted, it is eliminated and not checked, and the counter of incorrect access
attempts remains unchanged.
If the code inserted is correct, the management page (
) of the home automation plant.
If the code inserted is wrong, or no code is inserted before pushing the
ACCESS
button, an
error message appears. The counter of the failed access attempts is increased by 1.
The maximum number of failed access attempts is 21 (the limit is set by the burglar alarm
control panel and cannot be changed). If an incorrect access code is inserted for more than
21 cons
ecutive times, the control panel generates a “wrong code” alarm.
