30
Installation/Configuration ER600
9.2.4
Programming procedure
Proceed as follows to program the wireless inputs:
1) Enter
<Installer code>
, press
, then
and finally
repeatedly until PROGRAMMING
appears
2) Press
and then press
several times until RADIO DEVICES appears.
3) Press
.
4) Press
and
to select the required radio expansion module. Press
to confirm.
5) Press
and
to select SIRENS. Press
to confirm.
6) Press
and
to reach SELECT SIREN. Press
to confirm.
7) Press
and
to select the required siren. Press
to confirm.
8) Change the logical address using keys
and the numeric keypad. Press
to confirm.
IMPORTANT!
There cannot be two outputs with the same logical address
9) Press
.
10) Press
. Enter a descriptive name for the input using the keypad. The name can be up to 24
characters long. Press
to confirm.
11) Press
.
12) Press
. Press
and
to select “MSG OUTPUT ON” o “MSG OUTPUT OFF”. Vocal names
can be attributed to each status. Press
to confirm. Press
to play the vocal name of the
input.
13) Press
. To record, press
.
14) Press
to cancel the vocal message of the input.
15) Press
repeatedly until the screen page shown here by the side appears.
16) Press
.
UT00:INSTALLER
PROGRAMMING
PROGRAMMING
RADIO DEVICES
RADIO DEVICES
ER01:ER 01
ER01:ER 01
SELECT IR
SIRENS
ASSIGN
SIRENS
SELECT SIREN
HP01. U01
LOGIC NUMBER
LOGIC NUMBER
U01...
HP01. U01
NAME
NAME
U10:...
HP01. U01
VOCAL NAME
MSG OUTPUT ON
PLAY
MSG OUTPUT ON
RECORD
MSG OUTPUT ON
DELETE
SIRENS
SELECT SIREN
SIRENS
ASSIGN
