24
Installation/Configuration ER600
8 - CONTROL DEVICES
8.1
RC600 REMOTE CONTROL
Figure 8
– RC600 remote control
Ref.
Description
Use or indications provided
Key 1
Arm
Arms all associated partitions.
Key 2
Disarm
Disarms all associated partitions.
Key 3
Partial arm
Arms all associated partitions.
Key 4
Programmable according
to control unit
This key can only be used to arm/disarm OUTPUT devices or to generate four
different alarm types: silent panic, panic, emergency, fire.
5
Two-colour red/green LED
Red blinking
once and green once
=
the control requested by pressing the
button was received and performed by the control unit
LED blinking red six times and green once =
the control requested by
pressing the GENERIC button was received and performed by the control unit
LED blinking red three times =
the control requested by pressing the button
was NOT received and performed by the control unit.
The indications disappear after short while.
6
Battery housing
The remote control is powered by a
CR2032
3 V lithium battery
Note:
The ER600 radio expansion
must be installed to use the remote control.
