12
Installation/Configuration ER600
4 - INSTALLATION
4.1
INSTALLATION PROCEDURE
WARNING!
The ER600 radio expansion may be used only on systems with MP500/4N
– MP500/8 – MP500/16 control panels
in which the control panels and keypads run SW version equal to or higher than 1.05; otherwise, the ER600 will not be
acquired.
4.1.1
Battery compartment and fastening points for the ER600 in the MP500/4N - MP500/8 control panels
Figure 1 - Fastening points for optional features in the MP500/4N - MP500/8 control panels
The fixing point "
A
" is the one to use for radio expansion.
4.1.2
Assembling ER600 expansion in the MP500/4N - MP500/8 control panel
IMPORTANT!
The connection and disconnection of the ER600 must always be done while the control panel is disconnected
(both mains and battery).
Figure 2
– Fastening points for optional features in the MP500/4N - MP500/8 control panels
The position
D
calls for the assembly of the board in the raised position and turned 90°, inserting the board into slot on the right and
fastening it with 2 self-tapping screws onto the two supports on the left; the programming (PROG) key must be on the bottom right of
an ER600 is installed.
The expansion must be fastened with the self-tapping screws supplied.
ER600
