ELKHART BRASS APEX-S, Инструкции по установке, эксплуатации и обслуживанию, Страница: 8 / 24

8
INSTALLATION
The APEX valve controller is compatible with unibody valves used in 1.5 to 8 inch piping.
Install Valve Controller
1 Measure and mark mounting location for controller panel cutout and mounting screw holes
Make sure there is clearance behind the panel for the display and cables before cutting
holes Refer to Figure 2 for layout and dimensions
2 Cut out a mounting hole according to the cutout diagram in Figure 2, and drill three holes
(clearance or tapped) for #10 mounting screws
3 Connect the cables and wires (Refer to Wiring section )
4 *Place control module into position and secure with three screws
Use #10 size, Phillips pan head type screws with a minimum length of 1 25 inch
*NOTE: The Visor must be placed onto the valve controller housing prior to inserting
mounting screws and attaching to your apparatus.