ELKHART BRASS APEX-S, Инструкции по установке, эксплуатации и обслуживанию, Страница: 19 / 24

19
OPERATION
On power-up the valve controller will be in the normal operating mode. The green
OPEN
, red
CLOSE
, and yellow
PRESET
buttons will control valve position. The yellow
PRESET
button will set
the valve to a programmed position. Once a preset position has been programmed, pressing the
PRESET button will move the valve to that position.
The red LED will be on when the valve is in the fully closed position. The 10 green LED indicators
will show the valve position. Each LED indicator signifies 10 percent of the valve position. When
the valve is in the fully open position, all 10 of the green LEDs will be lit.
All information is supplied to the controller from the E14X or E16X electric actuator on the CAN bus.
Button Functions
Button Operations
Green OPEN button: Press and hold to drive a valve toward the Open position. Valve
will stop when the button is released, or when it is fully open.
Red CLOSE button: Press and hold to drive a valve toward the Closed position. Valve
will stop when the button is released, or when it is fully closed.
Yellow PRESET button: Press and release once; upon release the LED for programmed
preset position will flash and the valve will travel to that position and stop there.
To program a preset position move the valve to the desired position (full closed of full open or
anywhere in between) then press and hold the preset button until the valve position LED starts
flashing. Let up on the preset button and wait for the position LED to stop flashing. The new
preset position is now set.
Auto Travel OPEN and Auto Travel CLOSE
The auto travel OPEN method will fully open the valve when initiated.
1 Press and hold the OPEN button
2 While holding the OPEN button, press and release the CLOSE button
3 Release the OPEN button and the valve will automatically travel to the fully open position
The auto travel CLOSE routine will fully close the valve when initiated.
1 Press and hold the CLOSE button
2 While holding the CLOSE button, press and release the OPEN button
3 Release the CLOSE button and the valve will automatically travel to the fully closed position
Setting the PRESET Position
To set or change the preset position:
1 Use the OPEN or CLOSE buttons to move the valve to the desired position
(This can be fully closed, fully open, or somewhere in between )
2 Press and hold the PRESET button for until the LED(s) flash
3 Release the PRESET button and do not operate the valve until the LED(s)
stop flashing
Once the LED(s) stop flashing the new preset position will be saved