Features
– Dual purpose DALI Remote Control
– For use with Elkay easyDALi system
– User mode for day to day control
– Installer mode for installation set up
The easyDALI Remote Control consists of eight soft touch
buttons to control the Elkay easyDALi PIR (374-CMPIRDALI)
It can program basic installation and commissioning
functionality and has one hidden button that changes the
remote control from user mode to Installer Mode. Installer
Mode is detailed below but for End User Modes see separate
‘End User instructions’.
Installer Modes- How to program your easyDALi system
In Installer mode it is possible to control the timing options and
also select Room and Corridor Options
– Open battery cover at rear and remove paper tab from
battery area to enable the remote
–
You must turn lights OFF with the remote first to operate
and program in this mode
– To begin installer mode, remove battery cover at rear and
place pin in hole and press once. Once feed back light goes
RED
you are in Installer Mode
–
Installer Mode information should never be given to
End users of the system
Elkay easyDALi Remote Control
Instruction Data | 374-DREM
Installer mode only
A. Feedback LED -
continuous
RED
in Installer Option
E. Override ON/OFF Button
B. SET Button
For Walk test
D. Minimum Arc Power
Adjustment
Sets the minimum level the
harvester will not go below
1. Add group to pre-
addressed luminaires
2. Find pre-addressed
luminaires or address new
uncommitted luminaires
C. Mode Options Up and
Mode Options DOWN
Setting room timing options
and Corridor timing options as
per Table 1
4. Reset to Manual controls
3. Update all discovered
luminaires of the current
group with 16 pre-set levels
as scenes.
16 Green flashes
per ballast then a blue flash to
indicate complete
Installer Instructions
Remote Control Rear View
Small Hole
(Hidden
Installer Button)
Elkay easyDALi Remote Control Instructions must be read in
conjunction with Elkay easyDAli PIR 374-CMPIRDALI
Instructions in order to enable all features of the PIR.
