E 138
SPECIFICATIONS:
Model:
E 138
Lamp
:
LL-64514 120V/300W
Weight:
6lbs./ 36kgs.
Size:
12.3” L x 12.5” W x 9.6” H
Fuse:
5 Amp
Supply Voltage:
120V
Working Position:
Any Safe position
Duty Cycle:
None
Color Lenses:
Multi-Colored
Warranty:
1 Year Limited Warranty
CAUTION!
Please read and
understand these instructions
before installing or operating
this unit.
Introduction:
The E 138 has been tested and the lamp has been
installed at the factory, there is no assembly required.
The unit is ready to be plugged in to a power outlet.
This unit is a lightweight 4 unit in-sync system. Up
to 16 units can be connected together. It runs as a
stand-alone, system powered by 1 master unit and
3 slave units. The system comes with 16 sound
activated patterns. To enhance the beams use this
effect with a fog machine. This unit also looks great
in pairs.
Operating Instructions:
Using the provided cables, link the units together.
On the side of each unit, you will find a unit selec-
tor knob. With this selector knob, designate which
head is unit 1, unit 2, unit 3 and unit 4. The units will
now chase in that order. On the Master unit is mode
selector knob. You can choose between, chase
mode, sound active mode, flash mode, all on mode,
or 16 patterns
HALOGEN LAMP WARNING!
This fixture is fitted with halogen
lamps which are highly susceptible to
damage if improperly handled. Never
touch lamp with bare fingers as the
oil from your hands will shorten lamp
life. Also, never move fixture until
lamp has had ample time to cool.
Remember, lamps are not covered
under warranty conditions.
©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
Caution!
Never open unit when in use.
Always disconnect main power before
serving or replacing lamp. Remember to
always replace with the exact same type
lamp and fuse.
Lamp Replacement:
Disconnect the units main power supply. Unscrew and remove the two thumb
screws from the top of the unit. Remove the lamp trap door to expose the lamp. Remove and replace
the bulb. Reassemble and reconnect the power supply. Be sure to follow all the handling instructions
that are included with your new lamp.
