English
54
• Manually turn the drive pulley on the hydrostatic pump. This will enable the remaining oil
in the pump to be discharged into the collection reservoir. Continue until all the oil in the
hydraulic circuit has been drained.
• Now replace the hydrostatic filter with a new one and reconnect everything.
Caution:
Check to ensure that the new filter has been installed correctly, according to the
flow direction.
• Remove the collection reservoir.
• Place the machine on level ground.
• Now poor xx litres of fresh hydrostatic oil into the tank. ELIET recommends high quality
oil.
• Manually turn the drive pulley on the hydrostatic pump. This forces the inner workings of
the hydrostatic pump to become active, and all air in the pump is forced out so that it can
be filled with oil.
• Close the reservoir.
• Start the engine and move the machine a few metres.
• Check the oil level once again and top up if necessary.
Warning:
• Oil shortages in the hydrostatic pump inevitably cause severe damage. (This
type of defect is not covered under warranty).
• Respect the environment: take the oil to an authorised collection point for
expert processing or recycling. Never pour oil down the drain.
suction
Hydrostatic
filter
Klem
