English
47
• The following points require special attention:
o Check for any damage to visible electrical cabling, electrical connectors and switch
components.
o Inlet and outlet openings for cool air (read § 11.3.3)
o Battery
o Zones around turbine/cutter bearings
o Hydraulic vents and quick connectors
o Rubbish (snow residue, sticky detritus) inside the machine must be removed. Use a soft
brush, dry cloth or vacuum cleaner to remove this dirt.
o Particularly where safety stickers have been placed. (Do not use a cleaning agent that
will remove paint or stickers). Any stickers that are no longer legible must be replaced.
Original stickers can be purchased from your ELIET dealer.
• Use penetrating oil on MoS2 basis to remove dirty grease and lubricants. This spray is a
lubricant and rust solvent at the same time.
• After removing dirty lubricant it is important to reapply new lubricant in order to guaran
-
tee the proper functioning of the machine. (A list of recommended lubricants is included in
Appendix B).
• Compressed air can be used to easily blow out and clean some parts.
Caution:
Compressed air can damage the water-tightness of certain electrical compo-
nents!
• A vacuum cleaner is sufficient for removing dirt even if it is located at hard-to-reach loca
-
tions.
Warning:
If you must remove the protective cover in order to perform maintenance, make
sure you replace this correctly thereafter. Safeguards are there to protect you.
