ELGO Electronic Z58-600 Series, Руководство по эксплуатации

Страница: 12 / 28

Pin Assignments
- 12 -
7 Pin Assignments
7.1 Connection of Z58-600 (Standard 24 VDC)
Table 2: Pin Assignment of Z58-600
Rear (example full assembly) 1 Pin ST1 - (standard encoders)
1 0 V / GND (encoder supply)
2 +5 V or +24 V out (encoder supply)
3 Channel A
4 Channel B
5 Screen / shield
6 Channel A‘ (only with 5 V encoders)
7 Channel B‘ (only with 5 V encoders)
8 Channel Z‘ (only with 5 V encoders)
9 Channel Z
Pin ST2 - (power supply and external inputs) Pin ST3 - (FMAX / EMAX, relays, analog outputs)
1 Screen / shield 1 Screen / shield
2 0 V / GND 2 0 V / GND (encoder supply)
3 +24 VDC (power supply voltage) 3 +5 V / +24 V out (encoder supply)
4 Tool-offset (active high) 4 RS422_RX’
5 Reference (active high) 5 RS422_RX
6 Reset (active high) 6 RS422_TX’
Pin ST4 - (differential encoders) 7 RS422_TX
1 0 V / GND 8 n. c.
2 +5 V / +24 V out (encoder supply) 9 Analog output (0 ... 10 VDC)
3 Channel A 10 Analog output (0/4 ... 20 mA)
4 Channel B 11 Relay_1_A
5 0 V / GND (encoder supply) 12 Relay_1_B
6 Channel A‘ 13 Relay_2_A
7 Channel B‘ 14 Relay_2_B
8 Channel Z Pin ST5 - (RS232 interface)
9 Channel Z‘ 2 TxD
Inverted signals are marked with '
3 RxD
5 0 V / GND
REMARK!
When using encoders with 24 V resp. 10 ... 30 V signals,
the inverted signals must not be connected.
1
Depending on version and selected options, only the relevant connectors are fitted resp. terminals are occupied
ST5
ST4
ST3
ST1
ST2
1 2 3 4 5 6 7 8 9 10 11 12 13 14
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6