ELGO Electronic PMIX Series, Руководство по эксплуатации

Страница: 12 / 20

Installation and First Start-Up
- 12 -
5 Installation and First Start-Up
CAUTION
Please read the operating manual carefully before using the device! Strictly observe the Installation instructions!
In case of damage caused by failure to observe this operating manual, the warranty expires.
ELGO is not liable for any secondary damage and for damage to persons, property or assets.
The operator is obliged to take appropriate safety measures.
The first start-up may only be performed by qualified staff that has been trained and authorized by the operator.
5.1 Operating Area
WARNING!
Do not use the device in explosive or corrosive environments!
The device must not be installed close to sources of strong inductive or capacitive interference or strong electrostatic
fields!
NOTE: External Magnetic Fields
The magnetic tape must not be influenced by external magnetic fields! The PMIX cylinder equipped with magnetic
tape must not come into direct contact with other magnetic fields (e.g. permanent magnets, magnetic clamps, elec-
tromagnets, magnetic stands)! This may cause irreparable damage, which will compromise the measuring accuracy
or even the functioning.
CAUTION!
The electrical connections must be made by suitably qualified personnel in accordance with local regulations.
The device may be designed for switchboard mounting. During work on the switchboard, all components must be de-
energized if there is a danger of touching the energized parts!
(protection against contacts)
Wiring works may only be performed in the de-energized state!
Thin cable strands have to be equipped with end sleeves!
Before switching on the device, connections and plug connectors have to be checked!
The device must be mounted in a way that it is protected against harmful environmental influences such as splashing
water, solvents, vibration, shock and severe pollution and the operating temperature must not be exceeded.