ELGO Electronic GMIX2 Series, Руководство по эксплуатации

Страница: 16 / 24

Installation and First Start-Up
- 16 -
7.3 Mounting the Sensor Head
To mount the sensor head, use 2 x M3 screws of adequate length.

see also section

6.2 Sensor Dimensions
During installation, the specified installation tolerances must also be adhered to:
7.3.1 Mounting Tolerances
Table 2: Mounting tolerances
Magnetic tape MB20-50-10-1-R
Sensor distance to the tape: max. 4.0 mm
Lateral offset: ± 1 mm
Tilt and pitch angle: ± 5°
Yaw angle: ± 1.5°
Figure 7: Mounting tolerances
max. 4.0 mm
± 1 mm
Sensor distance: Lateral offset:
Pitch angle: Tilt angle:
Yaw angle:
± 5°
± 1.5°