ELGi EN 30X-100, Инструкция по эксплуатации, техническому обслуживанию и запасным частям

Страница: 78 / 108

7.20 Controller Manual
Neuron XT quick reference 7.12
MAIN SCREEN DISPLAY
 Package Discharge Pressure
 Discharge Temperature
 Machine Status like Run, Load, Unload, Standby etc.
 Warning Messages
 Mode Information (see below)
Mode Information
1. PS – Pressure Schedule Enabled / UL – Unload Mode Enabled
2. L – Local / R – Remote / D – DCS
3. A / M – Auto Restart ON / Manual Mode
1 128x64 Graphical display
2 Navigation keys
3 Enter key
4 Start key
5 LED (Green - Start , Red - Stop/Fault )
6 Stop key
7 Reset key
1
4
5
6
7
2
3
Compressor Status messages
Status Description
Ready Ready for start
Star Motor running in star
Run Motor running in delta
Run load Compressor in load
Run unload Compressor in unload
Stop busy Stop sequence in progress
Emergency stop Emergency stop push switch is on
Temperature inhibit ±XX
While starting, if the discharge temperature is lower than the set inhibit temperature value,
you will see this message. ±XX denotes the live discharge temperature value. The compressor
starts only if the discharge temperature value goes above the set value.
Auto restart “seconds”
If compressor is in auto mode, The controller will ensure minimum delay (user set, e.g. 60
sec) between stop and start. count stops if "STOP" key is pressed
Start ack wait…
This message is displayed after a fault is cleared and waiting for user acknowledgement. By
pressing “RESET” key user can acknowledge.
Standby Compressor in standby mode.