ELGi EN 30X-100, Инструкция по эксплуатации, техническому обслуживанию и запасным частям

Страница: 51 / 108

6.19
Maintenance
If you do not intend to use the compressor or any of its
parts, you must dismantle and put it out of service. These
tasks must be performed in compliance with the standards
in force of that particular country.
6.3.1 Waste disposal
 Use of the compressor generates waste. The residues
from agricultural, industrial, crafts, commercial, and
service activities must be treated as waste, which needs
to be disposed of properly. Deteriorated or obsolete
machines are also classified as waste.
 Special attention must be given to active carbon filters
as they cannot be included in urban waste. Observe the
waste disposal laws in force where the compressor is
used.
 It is mandatory to record loading or unloading of
exhausted oils, obsolete machines, and toxic harmful
wastes that derive from heavy or light industry
processes.
 It is especially important that exhausted oils be
disposed of in compliance with the laws in the countries
of use.
6.3.2 Dismantling the compressor
 Dismantle the compressor in accordance with all the
precautions imposed by the laws in force in the country
of use.
 Before dismantling, request an inspection by the
relevant authorities. Disconnect the compressor from
the electrical system.
 Eliminate any interfaces the compressor may have with
other machines, making sure that interfaces between
remaining machines are unaffected.
 Empty the air oil tank containing the lubricating oil and
store in compliance with the laws in force.
 Proceed with the disassembly of the individual
compressor components and group them together
according to the materials they are made of: Steel,
Stainless Steel, Aluminum and plastic parts.
 Then scrap the machine in compliance with the laws in
force of the country of use.
6.3.3 Decommissioning the compressor
 Remove the foundation for the compressor.
 Unplug the power cable entry to the compressor.
 Drain the oil from the cooler and air oil tank. Dispose of
it properly.
 Make sure all the compressed air is vented out through
ball valves and safety devices residing in the
compressor.
 Ensure that all the external supply lines have been
properly disconnected from the compressor before
decommissioning.
6.3.4 Disposal of consumables and
replaced parts
 The moisture condensate separated from the
compressed air contains oil particles. Disposal of
condensate and the filter element is to be performed in
accordance with the pollution control norms prevailing
at the time of compressor installation or use.
 Parts of the compressor that are replaced have metal
and rubber components. These may be recycled and
disposed of according to pollution control regulations,
respectively.
 Rubber items such as AVMs, coupling elements, and O-
rings should be disposed of and replaced before running
again.
Decommissioning, dismantling and
putting out of service
6.3
The compressor does not give any warnings during short
operating times. If it is operated below the dew point and
moisture, then condensate may mix with oil. This will
reduce the lubricating quality of the oil and lead to damage
of the compressor.
ELGi is not responsible for the disposal of old oil or
condensate. It is the responsibility of the customer to
dispose of the foregoing in accordance with local
environmental statutory laws.
NOTE