Page 5
011822
1-888-651-3431
Step 7:
For this Step you’ll need the assembly we’ve created, and 2 Part G (Bike Arm Bars), 2 Part H
(Plastic cradles), 2 Part I (Rubber Insert For Bike Cradles).
We are now ready to slide two of the Bike Arms on the Part B uprights. For straight tube bikes, slant
tube frames 19’’ or less, and extraordinary frame configurations we suggest mounting Part G so that
the tube is to the inside of Part B upright. For extra large frames, slant tube frames over 19’’, and most
BMX frames we suggest mounting Part G so that the tube is to the outside of the Part B upright. See
images below for clarification. Once you determine which way you‘ll mount them, simply slide one
over the top of Part B, at least 3 inches below the holes at the top of the Part B. Tighten the Knob to
prevent Part G from falling all the way down Part B. Repeat for other side. Add Part H by sliding on
Part G, then insert Part I into Part H.
ARMS TURNED TO INSIDE OF Part B
(Straight Tube bike, slant frames 19’’ or smaller.)
ARMS TURNED TO OUTSIDE OF Part B
(Extra large frame, slant frames 19’’, BMX.)
