24
HMD8 DSP/
USER’S MANUAL
6.4.6
LISTENING ZONES
The idea behind the zones is to provide the possibility to divide the output channels when they are spatially distant
from each other so much as to consider them in different environments. The division into zones is therefore justified
if the layout of the output channels is distributed over different environments.
The image above shows the settings panel for the zones where you can rename them.
The selected zone avails of the controls shown in the image below:
One zone may contain more than one output channel.
The association of an output channel with a zone can be performed in the
settings panel.
The zone panel is showed in the image below.
Remark:
for this reason it is possible to associate each output channel only to one zone.
Remark:
the graphic interface behavior related to the output channels changes according to the selected zone.
1
2
3
Selection button:
select the zone.
Zones settings panel:
access the zones settings panel.
Help:
to open the user guide.
1
2
3
Mute and solo:
allows you to mute all the channels of that zone (mute) or to listen to them silencing the ones
belonging to other zones (solo).
Zone level:
adjust the zone level.
1
2
2
1
6
