ELETTROLASER MS 3.5, Руководство пользователя и по обслуживанию

Страница: 83 / 108

code: UMS012 review: 0.2 date: 20/04/2022
Laser Welding machine - MS 3.5
user and maintenance manual page 83 of 102
8.5.4.6
Network settings page
The machine can be connected to an Ethernet and/or Wi Fi network.
The RJ45 socket (Fig. 6-13) is located on the rear of the machine.
Fig. 8-12 –
Network settings page (Ethernet)
Fig. 8-13 –
Network settings page (Wi Fi)
When pressed, this control area allows the operator to display the network settings for an Ethernet network.
When pressed, this control area allows the operator to display the network settings for a Wi Fi network.
When pressed, this control area allows the operator to enable/deactivate the DHCP protocol that automatically assigns the
machine the various parameters needed for its operation on the network it is connected to.
Note: When the DHCP protocol is enabled, the settings described under item 5 cannot be edited.
When pressed, this control area allows the operator to enable/deactivate the interface.
When pressed, these control areas allow the operator to set the various parameters needed for the machine to operate
on the network it is connected to.
Note: Some parameters can only be edited if the DHCP protocol is deactivated.
When pressed, this control area allows the op erator to “save” the settings on this page.
When pressed, this control area allows the operator to return to the “Settings” page (paragraph 8.5.4).
When pressed, this control area allows the operator to enable/deactivate the settings as a supervisor.
7
4
6
3
1
2
5
1
2
4
3
5
7 6
8