ELETTROLASER MS 3.5, Руководство пользователя и по обслуживанию

Страница: 77 / 108

code: UMS012 review: 0.2 date: 20/04/2022
Laser Welding machine - MS 3.5
user and maintenance manual page 77 of 102
8.5.4.1 Parameters page
Fig. 8-8 – Parameters page
This display area shows the idle time, in minutes, after which – unless the pedal is pressed – the machine will automatically
shift into stand-by mode (the resonator shutter will activate and interrupt the laser path).
Next to this area you will find the

and

controls. When pressed, these controls allow the operator to increase or
decrease the set value.
When pressed, these control areas allow the operator to lift  or lower  the motorized up-down support (optional
machine accessory, sold separately).
When pressed, these control areas allow the operator to turn on or turn off the class 1 laser pointer, which projects a
dot (optional machine accessory, sold separately).
View-only area displaying the instantaneous values of the electrical welding characteristics.
View-only area displaying the temperature (°C) of the cooling liquid.
View-only area displaying the temperature (°C) of the PFC source.
View-only area displaying the temperature (°C) of the welding machine CPU.
When pressed, this control area allows the operator to display the log file.
When pressed, this control area allows the operator to view the history of all warnings flagged by the machine.
For a list of warning messages, please refer to paragraph 8.5.4.2.
When pressed, this control area allows the operator to return to the “Settings” page (paragraph 8.5.4
1
2
3
5
6
9 8 10
7
4