Ventero-868 Operating instructions
28 190.0002
Warning!
Important safety instructions!
Observe the following instructions.
•
Only use unmodified original
elero
electrical parts.
•
Keep persons away from the operating range of the
system.
•
Keep children away from the controls.
•
Follow the relevant country-specific regulations.
•
If one or more devices are used for controlling the
system, the operating range must stay visible during
operation.
•
The device contains swallowable small parts.
Intended use
The Ventero-868 may
only
be used for controlling roller shutter,
awning and blind systems.
Third-party devices should only be connected after consultation
with your specialised dealer.
• Please ensure that the radio installations are not operated in
areas of heightened possible interference.
(e.g. hospitals, airports...).
• The remote control is only approved for devices and systems
for which any malfunction of the manual transmitter or receiver
would not result in a risk for persons, animals or property, or if
such a risk is covered by other safety devices.
• The operator has no protection whatsoever from interferences
by other radio emitters and local terminals (e.g. also from radio
installations), that are normally used on the same frequency
range.
• Only use radio receivers with equipment and units approved by
the manufacturer.
General information
The Ventero-868 is a wireless-operated wind control device for
your awning.
Integrated solar cells enable autonomous function of the device.
Radio signals (frequency 868.3 MHz) are transmitted between the
Ventero-868 and the motor.
The awning can be operated manually via a manual/wall
transmitter.
Safety instructions
Device function
The wind speed is measured at intervals and compared with the
set value.
Wind value above set value
→
Awning retracts or remains
retracted and is blocked for
around 15 min. (red LED flashes)
The wind function is always active.
However, in the event of a wind alarm, the keys are disabled for
15 minutes.
Charging the Ventero-868
The Ventero-868 is supplied in discharged condition.
1. Prior to commissioning, load the Ventero-868 for at least
minimum 30 minutes under a lamp or press the travel key for
at least 1 minute.
Advice:
the travel keys have two settings.
The first setting transfers energy from a built-in cell to the
energy store.
The second setting activates the travel command.
80
200
135
35
66
11
1
3
9
5
7
red LED
(Wind value)
green LED
(transmit)
DOWN
-
button
UP
-button
(Wind symbol)
Programming Ventero-868
Condition:
The end positions of the awning have been set,
a transmitter has been taught, and the Ventero-868
has been loaded (LED flashes when a key is
pressed).
Start programming mode
1.
Blind/shutter
runs up and
down for
2 minutes.
min. 3 sec.
elero
2.
3.
STOP
STOP
Press the ”
UP
”
(wind symbol)
button
immedi-
ately
after the
start of upward
travel.
Press the
”
DOWN
” button
immediately
after the start
of downward
travel.
„Teach-in“ programmed transmitter.
181150001_EN_0113
11
1
3
9
5
7
11
1
3
9
5
7
