elero DFE 100, Руководство по сборке, Страница: 14 / 16

5. Service
5.2 Notes on repair
Please contact us if you are unable to eliminate a problem.
When contacting our service team, please always state the article
name and number from the type plate.
When sending in the device for repair, please state the following:
– Item number
– Item description
– Application site of the drive
– Name of the connected controller
– Type of fault
– Accompanying conditions
– Own presumption
– Previously occurring unusual events
CAUTION!
Observe the following safety instructions.
Failure to observe them can lead to bodily injuries!
Risk of injury due to electrocution.
• Switch off the drive for cleaning and maintenance.
• Do not open the device housing.
5. Service
5.1 Fault table
Design
..M ..E Fault
Cause Remedy
• •
Drive does not run No voltage Check the mains connection
• •
Mains ok. Drive does not run Operating limit switch overrun Move manually inside the safety limit switch boundaries.
Check the phase sequence
• •
Safety limit switch ok. Emergency operation still active Remove NHK – crank
Drive does not run. Pull SHK chain into a neutral position.
• •
Drive is hot and does not run. Temperature limiter is off After cooling down the temperature limiter switches on
again automatically.
• •
End position is passed End position not set Set end positions.
or not reached.
5.3 Disposal
Please observe the current national regulations.
Dispose of according to the condition and existing regulations.
e.g. as:
• Electrical scrap (PCB)
• Plastic (Housing parts)
• Sheet metal
• Copper
Repair address:
elero GmbH
Antriebstechnik
Linsenhofer Straße 59–63
D-72660 Beuren
Phone (0 70 25) 13-01
Fax (0 70 25) 13-212
www.elero.com
Please visit us on the Internet if you require a contact outside
Germany.
14 | EN © elero GmbH