elero DFE 100, Руководство по сборке, Страница: 13 / 16

4. Manual operation
4.1 Opening/closing the limit switch cover
Observe the following instructions!
Non observation can lead to destruction of the drive!
• Open the motor and limit switch cover.
• Make sure than no objects etc. get into the connection area.
• Plug in the connecting cables and set the limit switch.
• Carefully close the motor and limit switch cover after the connections and adjustments are done.
• Make sure that there is no dirt or damage on the sealing surfaces.
• Close the motor and limit switch cover again and slide the limit switch cover so far up until it latches into place.
• It is essential to seal the cable gland correctly.
STOP!
CAUTION!
Observe the following safety instructions.
Failure to observe them can lead to bodily injuries!
• Manual operation is exclusively suitable for operating the door in the event of an emergency, e.g.: a mains failure.
Operation of NHK or SHK drives with a drill, etc. is forbidden.
• Keep the crank handle in the immediate vicinity of the door so that it is easily accessible at all times.
• Switch off the circuit breaker (main switch) before manual operation.
• No more travel commands must be present or given.
• Manual operation may only be made with the motor stopped and switched off.
• Manual operation may only be made from a safe position.
• Do not move the door beyond its end positions during manual operation.
• Install the supplied wall chain holder so that the reel chain is not hanging in the moving area and does not represent a
danger to persons or animals.
4.2 Safety instructions for manual operation
4.4 Operation with the haul chain
1. Pull the reel chain lightly up to the stop,
the control current is switched off.
2. Then open or close the door.
3. After operating the reel chain, turn the reel
wheel lightly back to its central position
until the emergency crank handle switch
switches the control current on again.
The door can now again be operated
electrically.
Changing the reel chain (round steel chain)
1. Open the reel chain on the closing link.
2. Remove some chain links.
or
Insert another round steel chain DIN 766 A4 x 16.
3. Close the closing link carefully.
The reel chain must not be twisted and must run easily on the
reel wheel.
4.3 Using the crank handle
1. Remove the plug from the crankcase of the drive.
2. Insert the crank handle by pushing and turning slightly until
it engages.
The control current is switched off.
The door can be opened or closed.
3. The crank handle must be withdrawn
after operation and the control current
is switched on again.
4. Fix the plug to the crankcase to
ensure compliance with degree
of protection IP 54/65.
The door can now again be
operated electrically.
© elero GmbH EN | 13