THE CARE & MAINTENANCE OF YOUR
SUPER DENSE MESH OR AQUA-XTREME MESH
LOOP-LOC SWIMMING POOL COVER
By following the simple instructions listed below, you can insure maximum performance of your LOOP-LOC MESH
Swimming Pool Cover for the years to come. The cover will have no problem supporting the weight of a child or an adult in
the case of an emergency. However, we do not recommend walking on it and never allow children or pets to play on top of
the cover. Adult supervision is always required around any swimming pool area.
INSTALLATION:
LOOP-LOC Safety Covers should be measured and installed by a swimming pool professional to
maintain all safety features and your pro-rated warranty.
TIGHTNESS:
Most important is that your LOOP-LOC cover be installed - and remain - tightly stretched across your pool,
resembling a trampoline. Upon its original installation, the adjustable springs on your LOOP-LOC cover should be
compressed about 90% for IN-GROUND and about 50% for ON-GROUND. The tension will gradually decrease in time,
adjust as needed to maintain 75% compression for Inground and 50% compression for ON-Ground.
SNOW SUPPORT
: During the snow season, the water level in your pool should be kept approximately 15” to 18” below
the top of the pool for IN-GROUND and 14” below the top of the pool for ON-GROUND. This is important for supporting
the weight of the snow on the cover. Allowing the water level to drop below 18” for IN-GROUND and 14” for ON-GROUND
will put excess stress on the cover and will void your warranty.
PERIODIC MAINTENANCE:
It is important to periodically check your LOOP-LOC Swimming Pool Cover to insure
mazimum performance in regards to ASTM guidelines. For example, in rare instances if non-warranty factors such as tree
limbs, animals, etc. cause a tear or rip in the fabric, it may result in the cover not being able to support the ideal weight to
meet the guidelines. All covers should be periodically checked for pre-mature U.V. deterioration which can void the safety
features of the cover. Please contact your local swimming pool dealer if you have any questions or to have your cover
repaired immediately. Please note: If your cover is a safety cover and is in need of repair, it will not be considered safe
and will not meet ASTM guidelines until the work is performed.
COVER REMOVAL/STORAGE:
Prior to removing your cover, hose it off while it is still installed across the pool, to
remove any debris that has collected on top.
When removing your LOOP-LOC, accordian-fold it and roll it into its storage bag. Hang the bag on a hook or nail (off
the floor) to allow the cover to drain through the bag and to protect it from rodents.
As with any valuable, high quality product, care should be exercised when installing or removing your LOOP-LOC.
Dragging the cover across the deck, over sharp edges or obstructions, or over raised anchor or bracket heads will damage
the cover.
ANCHORS FOR IN-G
GROUND COVERS:
In the spring and fall, remove all anchors and flush out all anchor
casings with a hose. This will prevent anchors from sticking when you re-install them.
When the cover is not in use, close the anchors completely, so they are flush with the deck. This will eliminate the
possibility of stubbed toes.
