Element RW80L, Руководство пользователя

Страница: 25 / 106

RW80L User Manual
25
6.3 Troubles Occur During Printing
Problem Description Probable Reason Solution
Blurred printing or spot
Incorrect roll paper loading Check if the roll paper is loaded
Unqualified roll paper
Use recommended thermal roll
paper
Dirty thermal head or print
roller Clean the thermal head or print
roller
Low print density Increase the print density level
Paper does not feed
normally
Paper jam
Open the printer cover, check the
paper path and remove jammed
paper
Vertical print words are
missing
Dirty thermal head or print
roller Clean the thermal head or print
roller
Thermal head damaged
Contact with your dealer for
assistance
6.4 Problems Emerge During the Paper Cutting
Problem
Description
Probable Reason Resolution
Cutter jam, the
movable cutter
cannot go back
Cutter abrasion,
insufficient cutting
Replace the cutter
Worn gear and worn
wheel abrasion
Replace the worn gear and worn wheel
Motor is burnt
Replace the motor
Paper scraps
Clean the paper scraps on the transmission system
Insufficient cutting
Cutter edge abrasion,
paper is too thick
Replace the cutter
Paper jam
Thermal printer head is
over-heated
Reduce the density of printing
Driving is too fast
Reduce the printer speed to the limit of thermal
printer head
Wrong paper feeding
position
Put the paper parallel with the paper mount and
insert into the space between platen roller and
the thermal printer head.
Note: Regarding the density of setting, please refer to "Utility Tool".