Elektror S-XP 240/40, Инструкция по эксплуатации и сборке, Страница: 15 / 24

15
EN
Operating and assembly instructions S-XP www.elektror.com
9020009 01.20/07
Note!
Check the ball bearings during servicing and
prior to recommissioning.
Operation is only permitted with fl awless ball
bearings!
Note!
In the event of frequently starting up and shutting
down, premature replacement of the bearings will
be required. Determining the time for replacing
the bearings is the sole responsibility of the main-
tenance and servicing personnel, who must make
a safety judgement.
Devices
Minimum ball bearing service
life
Horizontal motor shaft
S-XP 240/40 10.000 Hours
S-XP 245/20 7.000 Hours
Ball bearing change recommendation
- Prior to reaching the minimum service life
- 10 months following delivery at the latest
- Check after 6 months’ storage time; change if necessary
5.2 Rubber bu ff er (see also 3.1)
The rubber bu ff er between the motor and motor console are
checked regularly and replaced if damaged.
The rubber bu
ff er must be replaced with appropriate new
ones no later than after 20,000 hours. The rubber bu ff er are
designed for the system; therefore, we recommend the use
of original rubber bu ff er as spare parts.
5.3 Fine Filters
The extent of contamination on the fi lter mats should be
checked at regular intervals depending on the operating/am-
bient conditions. Thus, the permeability of the fi lters must be
guaranteed by the owner.
5.4 Cleaning
There is a high risk of injury on the inside of the device due
to rotating parts during operation. Before opening, reaching
in or inserting tools into the device, decommission the de-
vice in all cases and wait until all moving parts have stopped.
Secure the device reliably against accidental restart during
the entire period. Also make sure that no other dangerous
situation can arise when restarting after a standstill, e.g. as a
result of a power failure or blockages.
Cleaning or maintenance must not lead to damage or modi-
fi cations to the device and its components that a ff ect safety
or health protection and, for example, impair the balance of
the impeller.
When starting up the blower, make sure that all tools or other
foreign objects have been removed from inside the device
and that all covers and protective grilles have been attached
correctly.
6 SAFETY-RELATED INFORMATION
ON DECOMMISSIONING AND
DISMANTLING
The disconnection of all electrical connections and any other
electrical work in connection with decommissioning must
only be carried out by a quali fi ed electrician.
The device should be dismantled only when all rotating parts
have come to a standstill and cannot be restarted.
The guidelines set out in 2.1 Transport and Handling must be
observed when dismantling and removing it.
Treat the device as industrial waste when disposing of it.
The device parts are made of recyclable material, such as
aluminium, (stainless) steel, copper and plastic. However,
there are components that need special treatment (e.g. fre-
quency converters). The statutory national and local disposal
and recycling regulations must be observed.
7 LIABILITY AND EXCLUSION
OF LIABILITY
The owner shall bear the responsibility for the correct use of
the device.
Elektror shall not accept any liability for any use of its prod-
ucts and components whi is contrary to their intended use.
This shall also apply in particular to use in special applica-
tions and under operating conditions that have not been spe-
ci fi cally agreed with Elektror.
Elektror shall not accept any liability for any modi fi cations or
alterations to the device or accessories supplied.
Likewise, Elektror shall not be liable for improper, delayed,
neglected maintenance. Neither shall it be liable for any
cleaning and repair work not carried out by quali fi ed Elektror
specialists, nor for the possible consequences.