14. SETTINGS MENU
76
to select what will be received. Press
[YES]
to initiate the SysEx receive procedure. The Syntakt starts
listening to incoming data. Press
[NO]
to stop listening.
PATTERN
will store a received pattern to the selected pattern slot.
SOUNDS
will store a received sound to the selected slot of the +Drive sound library. The option
ANYWHERE will place the sound in the first free slot available. To the right of the bank indication, the
amount of free slots can be seen.
14.6 AUDIO ROUTING (GLOBAL)
Here you find number of audio routing options that affects the Syntakt on a global level. You can also set
the audio routing on a pattern level. For more information, please see “14.3.5 AUDIO ROUTING (PATTERN)”
14.6.1 EXTERNAL IN
Sets if the incoming audio from INPUT L/R is treated as a stereo signal or two mono signals.
14.6.2 MAIN
Use this option to customize which of the 12 2 effects (Delay, Reverb) that sends audio to the
MAIN OUT outputs. Use the
[TRIG 1–12]
keys and the
[FLTR]
, and
[AMP]
keys to activate/deactivate
send from each track and effect. Green keys signal send to main. Red keys signal do not send to main.
14.6.3 SEND TO DEL/REV
Use this option to customize which of the 12 the Delay effect that sends audio to the effects
(Delay, Reverb). Use the
[TRIG 1–12]
keys and the
[FLTR]
key to activate/deactivate send from each
track and effect. Green keys signal send to the effects. Red keys signal do not send to the effects.
14.6.4 USB IN
Sets where the incoming audio from the class compliant device is routed to in the Syntakt’s signal path.
This parameter is only available when
USB CONFIG
is set to USB AUDIO/MIDI. For more information,
please see “14.8.1 USB CONFIG” on page 77.
PRE-FX
the incoming audio is routed in before the Syntakt’s Analog FX block and will be affected by
this and then be sent at the main outputs.
POST-FX
the incoming audio is routed in after the Syntakt’s Analog FX block and will not be affected
by this. The audio is then sent at the main outputs.
OFF
No sound is routed from USB to the Syntakt.
14.6.5 USB OUT
S
ets from where in the Syntakt’s signal path, the outgoing audio is routed to the class compliant device.
This parameter is only available when
USB CONFIG
is set to USB AUDIO/MIDI. For more information,
please see “14.8.1 USB CONFIG” on page 77.
MAIN
the outgoing audio is routed from the Syntakt’s Main out at the end of the signal path.
TRACK 9–12, L:T9–12/R:T9–12
the outgoing audio is routed from the selected track(s) Press a
[TRIG]
key twice to select a single track as a destination. The selected track’s
[TRIG]
key lights up purple.
Press first one
[TRIG]
key and then another to select two separate tracks as sources. The selected
tracks’
[TRIG]
keys lights up blue for left channel and red for right channel. The audio from the tracks
is then routed out and sent separately on left and right channel.
EXT
the outgoing audio is routed straight from the Syntakt’s audio inputs INPUT L/R to the class
compliant device.
OFF
no audio is sent to the class compliant device.
