Elektron Digitone, Руководство пользователя, Страница: 28 / 86

10. THE SEQUENCER
28
cate steps that do not contain any trigs. Read more about parameter locks in section “10.10.1 PARAME-
TER LOCKS” on page 34. The two types of trigs are added differently in the sequencer, depending on
whether GRID RECORDING or LIVE RECORDING mode is active.
10.2.2 GRID RECORDING MODE
GRID RECORDING is a method of composing where you use the [TRIG] keys to add trigs.
1. Press [TRACK 1–4] to select the track to which you want to add trigs. A green [TRACK] key light
indicates the active track.
2. Press [RECORD] to enter GRID RECORDING mode. The [RECORD] key lights up red to indicate
that GRID RECORDING mode is active.
3. Use the
[TRIG]
keys to place note trigs on the sequencer. The trigs note value is the value spec-
ified by the ROOT parameter in the TRIG PARAMETERS page. For more information, please see
“11.2.1 ROOT” on page 39.
To add a lock trig, press [FUNCTION] and [TRIG] . You can enter lock trigs on any sequencer step,
including ones that contain note trigs.
Press the [TRIG] key of any of the previously entered trigs if you wish to remove the trig. Press a
[TRIG]
key of a trig and hold it slightly longer to prepare the trig for editing, rather than removing it.
4. Select another track, and add note trigs and lock trigs. Repeat the procedure for all the tracks you
want to use.
5. Press [PLAY] to listen to the sequence.
• Add micro timing to a note trig by pressing and holding the [TRIG] key and then press
the [LEFT]/[RIGHT] keys. For more information, please see “10.6 MICRO TIMING
MENU” on page 31..
• If the pattern contains more than 16 steps, select the pattern page you want to edit by
pressing the [PAGE] key. A fully lit <PATTERN PAGE> LED shows the active pattern
page.
• All trigs of a track can be shifted forwards or backward on the sequencer. While in GRID
RECORDING mode, hold down [FUNC] while pressing the [LEFT] or [RIGHT] arrow
keys to perform the trig shift.
10.2.3 GRID RECORDING USING TRACK NOTE METHOD
This is an alternative way to enter note trigs in GRID RECORDING mode that gives you more control over
what note values you want to add to a specific step in the sequencer.
1. Press [TRACK 1–4] to select the track to which you want to add note trigs and additional notes. A
green [TRACK] key light indicates the active track.
2. Press [RECORD] to enter GRID RECORDING mode. The [RECORD] key lights up red to indicate
that GRID RECORDING mode is active.
3. Press the [TRIG] key to where you want to add or remove notes + [TRACK NOTE] . A graphic
keyboard appears on the screen where you can see all the notes on the chosen sequencer step. A
key with a dot on the screen keyboard indicates added notes.
4. Press the [TRIG] keys to add notes with the corresponding note value. Press the [TRIG] key of a
previously entered note if you wish to remove that note.
5. Press [YES] to enter the changes and then exit . Press [NO] if you wish to exit without making any
changes .