Elektro-Automatik PS 9000 2U Series, Руководство по эксплуатации, Страница: 106 / 134

Page 38
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de
PS 9000 2U Series
2.3.13 Initial network setup
The device is delivered with default network parameters (see
„3.4.3.6. Menu “Communication”“
). The Ethernet/
LAN port is immediately ready for use after the initial commission.
For wiring, i.e. the hardware connection to a network, contact and ask your IT manager or any similar responsible
person. Network cable of common type (CAT5 or better) can be used.
In order to set up the network parameter to your needs, you have two options: the setup menu or the device’s
website. For the configuration in the setup menu please refer to
„3.4.3.6. Menu “Communication”“
.
For the configuration via the device’s website, you need the device to be connected to a network or directly to a
PC which can access the default IP 192.168.0.2.
► How to do the network setup on the device website
1.
In case the device display is in any kind of menu, lave menu to main display.
2.
Open the device website in a browser by entering the default IP (http://192.168.0.2) or the default host name
(http://Client, only possible if there is a running DNS in the network) into the URL box.
3.
After the website has been completely loaded, check the status field item “ Access ” to show the status “ free ”.
In case it shows different, the device is either already in remote control ( rem ) or blocked from remote control
( local ). If it shows “ local ”, first remove the block. Refer to section
„3.5.2. Control locations“
to do that.
4.
If it says “ rem ” in the “ Access ” item, skip to step 5. Else enter command syst:lock on (attention! space
before on ) into the SCPI command box and send with return key. Check if item “ Access ” in status field
changes to “ rem-eth ” (means: remote Ethernet).
5.
Switch to page CONFIGURATION (upper left corner) and set up the network parameters as well as the port
here resp. activate DHCP and submit the change with SUBMIT button.
6.
Wait a few seconds before testing the new IP by entering it in the browser’s URL box. Opening the website
again by using the host name is only possible after the device has restarted, because only then the new IP
is reported to the DNS.