background image

Installation manual Electronicbox Ver. B, 03.2020

No time for manuals? No problem, it will take only 2 minutes of your time to read it and

you will have more fun while the installation of your new B - Box.

+

12 Volt main (Red)

: This is the 12 Volt main line. It is wired

 afte

r

 the ignition key switch 

if you don´t use the

 

optional avaliable RFID antenna. It is wired 

direct to the battery

 if you use the RFID antenna as keyless go system.

Ground (Black): 

This cable is connected to battery minus / ground. By the way, it makes sense to connect the

 

handle bar ground with the frame ground with a wire. The bearrings to the fork have usually not a good 
connection to the frame what might result in „funny“ unwanted effects.

Button input start: 

This input is wired to the start button.

Button - or killswitch input Ignition

: This input is wired to the ignition switch or to the engine stop switch. 

You

 

switch on or off the ignition by a press on the button or by open the engine stop switch

Input brake switch: 

Just connect the brake switch(es) to this input. The brake light is activated by switching this input

to ground. By the way, the B - Box can let the brake light glow with 40 % if no brake switch is closed (...see option 1 in
the table). In this case you need only 1 cable to the rear light / brake light.

Button or switch input for the headlight: 

This is the connector for the head light switch. The head light changes

 

when this input is connected to ground. In the button mode you can switch off the head light by pressing and hold the
button for 2 seconds.

Button input horn: 

The horn output is activated when this input is switched to ground.

Button or switch input left indicators: 

The left flashers are activated when this input is switched to ground

Button or switch input right indicators: 

The right flashers are activated when this input is switched to ground.

By the way, you can activate an emergency flasher function by a press on both buttons at ths same time if the 
„Button mode“ is be choosed.

Input side stand switch

: This input can be connected to the side stand. The ignition will switch off in the case if 

the

 

option 1 in the table is activated and the gear box of your bike is not in the neutral position.

Input neutral switch: 

If you have option 1 of the table activated you can only start your bike if the ignition 

switch

 

is closed to ground.

1 / 3

Отзывы: