57
ENGLISH
Figure 29 Cleaning filters and arms
•
At the end of cleaning operations, refit the previ-
ously removed parts.
•
Close the machine door.
I4.2
Exterior cleaning
Clean the stainless-steel surfaces with lukewarm
soapy water (do not use detergents containing abra-
sive substances, steel wool, brushes or scrapers in
common steel) then rinse with a wet cloth and dry
carefully.
I5
Long idle periods
Whenever the machine is not going to be used for a
long period of time (e.g. one month), carefully carry out
the following instructions.
•
Completely empty the tanks as indicated in par. I3.7
“Accessory functions”.
•
After draining the tanks, press the On/Off key (“A” -
Table 5 “Control panel”) to switch off the dish-
washer.
•
Turn the main switch of the machine to “O”.
•
Close the water supply cocks.
•
Clean the inside and outside of the machine as
indicated in par. I4.1 “Daily internal cleaning” and
I4.2 “Exterior cleaning”.
•
Spread a film of paraffin oil over the steel surfaces.
When using the machine again, follow the indications
in par. I3 “Daily activation of machine”.
I6
Maintenance
Inspection and maintenance intervals depend on the
actual machine operating conditions (total wash hours)
and ambient conditions (presence of dust, damp, etc.),
therefore precise time intervals cannot be given. In any
case, to minimize interruptions of the service, careful
and periodical machine maintenance is advisable.
Therefore, it is advisable to:
•
Descale the boiler, inside surfaces of the tank and
the machine piping once or twice a year (call tech-
nical assistance).
•
Every month descale the prewash, wash and rinse
jets with vinegar or scale remover.
•
Once or twice a year clean the finned coil of the CU
(call technical assistance).
It is also advisable to stipulate a scheduled pre-
ventive maintenance contract with technical
assistance.
I7
Machine disposal
At the end of the product’s life cycle, make sure the
equipment is not dispersed in the environment. The
equipment must be disposed of in compliance with
current regulations in the country of use.
All metal parts are in s/steel (AISI 304) and removable.
Plastic parts are marked with the letters of the mate-
rial.
The symbol
on the product indicates that this
product should
not
be treated as domestic waste, but
must be correctly disposed of in order to prevent possi-
ble negative consequences for the environment and
the human health.
Regarding the recycling of this product, please contact
the sales agent or dealer of your product, your after-
sales service or the appropriate waste disposal serv-
ice.
IMPORTANT!
Make sure the MAIN SWITCH of the
machine is locked in the Off position -
“O”.
