The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
A
12.5 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Before you replace the lamp:
Step 1
Step 2
Step 3
Turn off the oven. Wait un‐
til the oven is cold.
Disconnect the oven from
the mains.
Put a cloth on the bottom
of the cavity.
Back lamp
Step 1
Turn the glass cover to remove it.
Step 2
Clean the glass cover.
Step 3
Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4
Install the glass cover.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
In any cases not included in this table
please contact with an Authorised
Service Centre.
Problem
Check if...
The oven does not
heat up.
The fuse is blown.
Problem
Check if...
The door gasket is
damaged.
Do not use the
oven. Contact an
Authorised Service
Centre.
The display shows
"12.00".
There was a power
cut. Set the time of
day.
The lamp does not
work.
The lamp is burnt
out.
ENGLISH
25
Содержание KOIGH00KA
Страница 1: ...KOIGH00KA EN Oven User Manual ...
Страница 27: ......
Страница 28: ...www electrolux com shop 867360992 A 132021 ...