Electrolux KGV9539IK, Руководство пользователя, Страница: 22 / 28

7.6 Periodic maintenance
Speak to your local Authorised Service
Centre periodically to check the
conditions of the gas supply pipe and the
pressure adjuster, if fitted.
8. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem Possible cause Remedy
You cannot activate or op‐
erate the hob.
The hob is not connected
to an electrical supply or it
is connected incorrectly.
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Refer to the
connection diagram.
The fuse is blown. Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
You do not set the heat
setting for 20 seconds.
Activate the hob again and
set the heat setting in less
than 20 seconds.
You touched 2 or more
sensor fields at the same
time.
Touch only one sensor
field.
There is water or fat stains
on the control panel.
Clean the control panel.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
You put something on one
or more sensor fields.
Remove the object from
the sensor fields.
The hob deactivates. You put something on the
sensor field . Remove the object from
the sensor field.
Hob²Hood function does
not work.
You covered the control
panel.
Remove the object from
the control panel.
The sensor fields become
hot.
The cookware is too large
or you put it too near to the
controls.
Put large cookware on the
rear burners if possible.
There is no sound when
you touch the panel sensor
fields.
The sounds are deactiva‐
ted.
Activate the sounds. Refer
to "Daily use".
www.electrolux.com 22