Technical Support - DMM
37/106
599 77 23-65 Rev. 03
8.3 Rapid reading of alarms
The last alarm can even be displayed if the selector is not in the tenth diagnostic position
or the machine is in normal operation (e.g. while a washing programme is in
progress):
→ Press the
START/PAUSE
button and the nearest
option button
simultaneously (as if you were entering
DIAGNOSTIC mode) for at least 2 seconds: the LCD display shows the last alarm.
→ The alarm continues to be displayed until a button is pressed.
→ The alarm reading system is as described in para. 8.2
→ During the time that the alarm is displayed, the appliance continues to perform the cycle or, if you
in the selection phase any options that have already been selected will remain in the memory.
8.4 Deleting the last alarm
It is good practice to cancel the alarms stored:
After reading the alarm codes, to check whether the alarm re-occurs during the diagnostic cycle
After repairing the appliance, to check whether or not it occurs again during testing
Series 7
Series 8
Series 9
1. Enter the diagnostic mode,
2. Turn the selector dial clockwise until the eleventh LED is turned on (in the left-hand alarm reading row)
3. Press/touch the
START/PAUSE
button/sensor and the nearest
option
button/sensor
simultaneously
(as shown in the figure)
4. Hold down the buttons until the LCD display shows
“E00” (at least 5 seconds).
N.B. With this operation all the alarms stored are deleted.
