Electrolux EWT 1058, Инструкция по эксплуатации

Страница: 24 / 26

24
Levelling
Level the appliance by raising or lowering the feet.
Precise levelling prevents vibrations, noise and the
machine moving whilst operating. After levelling, lock
the feet by tightening the rings by hand or with a
screwdriver.
Moving the appliance
To move the appliance, simply place it on its rollers by
pulling the lever located at the bottom of the appliance
from right to left. Once the machine is in the desired
position, return the lever to its initial position.
Water inlet
Screw the supply hose connector onto the threaded end
of the water inlet tap (20x27 mm), taking care to correctly
position the seal A, located in the bag supplied with the
appliance.
The water inlet pipe must not be extended. If the pipe is
too short, purchase a longer high pressure hose.
To other end of the water inlet hose, on the appliance
side, can be orientated in any direction. Undo the
tightening ring slightly, rotate the end of the pipe and then
do up the ring securely.
Draining
The end of the drain hose can be placed in two different
ways:
In a drain pipe (or branch of the sink drain pipe),
of which the distance from the floor must be between
70 and 100 cm.
It is essential to have an air gap at the end of the drain
hose to prevent any siphoning.
In addition, the drain hose should not be bent. It
should be placed on floor level with the end being
located at the height specified above.
Over the edge of a sink using the plastic section
supplied with the appliance :
In this case, ensure that the end cannot fall out onto
the floor when the machine is draining. For example,
you can secure it with a piece of string to the tap or
secure it to the wall.
Important:
Under no circumstances must the drain hose be
extended.
Failure to comply with these rules may lead to your
appliance not functioning correctly.
A