Electrolux EWT 1058, Инструкция по эксплуатации

Страница: 20 / 26

20
Symptoms
The machine vibrates or is very
noisy.
The lid does not open.
The wash cycle is much too long.
The machine stops during a wash
cycle.
The laundry is not spun
sufficiently or water remains in
the drum (error code E20).
Softener flows out of the overflow
hole.
Solutions
Check that:
-
the transit bolts have been removed (see "removing
transit bolts" section),
- the appliance is level and installed correctly,
- the appliance is not too close to a wall or other
furniture,
- the laundry is correctly distributed in the drum,
- the appliance is not overloaded.
- the appliance is in the heating phase,
- the lid is still locked.
Check that:
-
the water pressure is sufficient,
- the water inlet filter is not blocked,
- there is not a water cut
Check that:
-
the water pressure is sufficient,
- the water inlet filter is not blocked,
- the fuses are in good condition and have not blown,
- the appliance is not finishing its wash programme
by a rinse hold.
Check that:
-
the drain hose is not kinked,
- the height of the end of the drain hose is not higher
than on metre,
- the drain pump filter is not blocked ("Filter" light
illuminated),
Check that:
-
you have used the correct amount,
- the siphons on the rear of the detergent dispenser
are not blocked.